Calcite Powder Making

2020-12-21

We crush large pieces of calcite material by the hammer crusher to the fineness (15mm-50mm) that can enter the mill. The small pieces of calcite material after crushing are sent to the silo by the elevator, and then sent to the silo by the vibrating feeder. It is uniformly and quantitatively sent to the grinding chamber of the mill for grinding.

Solution

XZM 325-2000mesh Powder Making

MTW 80-325mesh owder Making

For fine powder processing, LM vertical mills and MTW Raymond mills are generally used; for ultra-fine powder processing, LUM ultra-fine vertical mills and XZM ring roller micro-powder mills are generally used; for sand making or coarse powder processing, HM European coarse powder mill is used. Then the ground material is classified by the classifier, the unqualified powder then returned to the host for re-grinding. The fineness of the powder enters the dust collector through the airflow through the pipeline for separation and collection. The collected powder of the finished product is sent to the finished product silo by the conveying device through the discharge port, and then is packaged by a powder tanker or an automatic baler.

Too tired to read? Try staff service!

Engineer one-to-one for you, draw up plans in time, and provide investment estimates in time!

Maybe You Want To Read

Barite Processing by MTW215 Series Grinding Mill

Limestone Processing by MTW215 mill, one set, 45T/H

Calcium Carbonate Processing By XZM244 Ultrafine Mill

Equipment Selection For The Application Of Quicklime Powder

Coal Processing by LM130M Vertical Roller Mill

Hot Sale